|
Posted by Bill Stock on March 10, 2005, 8:22 pm
Please log in for more thread options
>
>> wrote:
>>
>> >I recently purchased a Won Brothers Pro Heat II aquarium digital
>> >aquarium
>> >heater for my 75 gallon. The old heater was too small and I plan to go
>> >with
>> >an auto water changer in the near future, which will only make matters
>> >worse.
>> >
>> >The box makes claims of +/- 1°F accuracy, which if you read carefully,
>> >refers to the digital readout, not the actual heater. The heater has a
>> >range of 68°F to 93°F. I currently have it set at 68°F, but the tank is
>> >reading 72.3°F on my thermometer and 71°F on the heater LED. I thought
>> >4°F
>> >of error was rather crappy given the +/- 1°F claims and the fact that I
>> >wanted to keep the tank around 70°F. I contacted the manufacturer about
>> >the
>> >large error, but they did not bother to respond.
>
> [snip]
>
>> I have yet to find a heater that is calibrated. The dial markings
>> seem to be approximate. I have come to assume the plus and minus are
>> a measure of how accurately the set temperature holds.
>>
>> Thus I set the dial to 78, the tank temperature settles at 76. I move
>> the dial to 80 and the tank settles at 78. Leaving the dial alone,
>> the measure temperature will vary plus or minus, there is always a
>> lag.
>
> Most of the heaters I've seen cycle on and off at a rate determined by
> the "temperature" setting of the control. If ambient temperature
> changes by a couple of degrees, the result is a corresponding change
> in water temperature since the thermostat is still adding the same
> amount of heat.
>
> I would be interested to see if your "Won Brothers Pro Heat II" actually
> had a temperature controller rather than a cycling heater in it. The
> former would actually measure the water temperature and adjust the
> on/off cycling rate to maintain constant temperature. If any one knows
> of a system that does this, I could really use one for my 120 gal. lab.
> tank - the room temperature is normally pretty constant, but if the
> outside temperature changes dramatically overnight, it can vary by as
> much as 6 F, and I have to go adjust the thermostat.
David,
I believe the external temperature sensor is used to control the temperature
AND display it on the LEDs. The temperature is far too stable for it to be
otherwise. I have a similar (different brand) titanium heater in the pond,
but without the digital readout. It also uses the external sensor to control
the temperature. Although I'm using a custom sensor and software to control
this unit, as my temp requirements are well below the range of the
thermostat. WB makes these things up to 1000Ws, more than enough to handle
your 120 G.
> Speaking of which, it's time for my daily tank check...
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML Sitemap